The OS 3.1 SetPatch command will load the 68040.library, but you need to replace the stock 68040 with the updated 68040 one. by commenting out the SetPatch command in S/Startup-Sequence).
AMIGA WORKBENCH 3.1 INSTALL DISK DOWNLOAD UPDATE
You can still boot without startup sequence, and you can (normally) boot to workbench w/o running setpatch at all (if needed – to update the system) (i.e. Note: If you try and install a 3.1 workbench install disk say eg: (rev 40.42) and get a software failure this is because the SetPatch command is loading the wrong 680×0.library from LIBS. Also lastly make sure that you have the latest Replay1 Firmware After this is done, apart from again setting up the card as shown in the docs link above, you then need to install the 060 libraries on your sdcard so as it will boot automatically with the replay.ģ) You will find the Motorola 040/060 library files here, or Ĥ) You should then be able to access the 060 from wb and or other software including the FPU etc.
AMIGA WORKBENCH 3.1 INSTALL DISK DOWNLOAD HOW TO
Also, see this link on how to create a replay Amiga sdcard and partitions from scratch. In this archive, it will show you the basic files required to boot the replay and a core. You must use these for the daughterboard and they cannot be mixed with the amiga_aga core files.Ģ) Note on SDcard setup: Assuming you have not already, you need to prior to this, setup an sdcard for the replay. This will include the following files, “ replay.ini“,” replay.rom” and “ replay_amiga_68060.bit“. How to setup the Replay1 060 Daughterboard and optional components.įirstly you need a working set of disks 3.1/3.1.4 preferably and you’ll need an updated ROM and other files from the one in replay release for the 060.ġ) Download the 68060 core files from and add them to your SDcard.
0 kommentar(er)
